|
| Site Partners: | SpotterGuides | Veloce Books |
| Related Sites: | Your Link Here |
|
|
|||||||||
|
||||||||||
|
|
|||||||||
|
||||||||||
|
|
29 Feb 2016, 09:35 (Ref:3618587)
|
#1 | |
|
Rookie
Join Date: Jul 2014
Posts: 14
 |
Upshift problem SRT-EDL64
Hello,
Upshift mode in SRT need gear sensor? Car has not them, so Gear barrel input is "0". In sysma I can see switch upshift ON in "Switch state window" when I put paddle, but ecu don't cut injection, ignition etc. I made log in Wintax - you can see parameters when Upshift switch state is ON. No ignition cut, no injection cut (injection corection = 1, so it's OK), no torque reduction and finally no second gear... No Error Configuration. Only in DiagAcqAna2 0x0400 (cam 1 pos) but I don't know why because Cam 1 input is "0"). What is wrong? Before with Vision with this same setup Upshift works good. 
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| SRT EDL64 - new flash | .wide | Racing Technology | 1 | 7 Sep 2015 11:55 |
| The future of SRT Viper | Beetle | Sportscar & GT Racing | 273 | 30 Apr 2015 13:19 |
| Dodge Viper SRT-10 Competition Coupe, where does it race? | Zandbak | Sportscar & GT Racing | 19 | 23 Jan 2004 20:59 |
Linear Mode
