Help needed RF94Z VanDiemen Suspension

[carsten.meurer]

I can't believe how long I have been away from here !

Mind I can't believe i had my RF94 laying in drawers for 24years either...

On my quest to get all my single seaters up and running again, we did
turn to the RF94 Zetec last winter.
The car was badly damaged back in 99, suffering a roll before the Villeneuve chikane that knocked all four corners and the bellhouse out.

Who would have thought that by the time you get a chance to look into it
you can't order from the factory anymoe. wow

Bought a bellhouse ages ago, and took the chance to buy a donor car, being assured it was what i needed lately.
Now to the point I need your help with !
If not here, I can't see anywhere else...

HELP !!!

My car WAS a wide track, but i fear the one i bought as donor is NOT.

Does anyone here recall or have notes about the difference, measurements of the wide track kit ?

I measure 177cm wiront now, while I am pretty sure we had it at 185cm that were maximum allowed back then.

Maybe you have setup sheets that give track width or lenght of wishbones and pushrods.
A totally bold wish would be that someone might even have suspension parts
laying about that i could buy ?!
Some might even recall what of the 93/94 wide track made it into 95 and successive chassis.

Wanted to set this call for help up before leaving on holiday.
With restricted web access responding might take a while, please don't be put off by that.

Looking to get it out again 30 years after it hit the track forst time round.

Thanks in advance from Germany

Carsten