|
| Site Partners: | SpotterGuides | Veloce Books |
| Related Sites: | Your Link Here |
|
|
|||||||||
|
||||||||||
|
|
|||||||||
|
||||||||||
|
|
4 Aug 2005, 13:40 (Ref:1371947)
|
#1 | |
|
Rookie
Join Date: Sep 2004
Posts: 25
 |
PI System 2 and MBE ECU - Settings
I'm having problems getting my PI System 2 dash to read the tacho signal from my 967 MBE ecu!
Have set the dash to accept 12v Pull-Up (Config C). Have set the pulses per 2 revolutions of crank to 4. For some reason the rpm ground connector on the back of the PI Dash has never been used to ground to a supply (car used to be a Zetec FF). Even when I earth this pin, there is no change. Anybody any ideas ?? Cheers. |
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Tracking Settings | Pug620 | Racing Technology | 6 | 24 May 2005 08:38 |
| Camara Settings | rdjones | Motorsport Art & Photography | 3 | 23 Jan 2005 12:30 |
Threaded Mode