Home  
Site Partners: SpotterGuides Veloce Books  
Related Sites: Your Link Here  

Go Back   TenTenths Motorsport Forum > Other Motorsports > Kart Racing

Reply
 
Thread Tools Display Modes
Old 28 Feb 2011, 11:34 (Ref:2837910)   #1
Spice52
Rookie
 
Join Date: Feb 2011
Posts: 1
Spice52 should be qualifying in the top 10 on the grid
Comer Cadet Tyres life? how long do they last?

Hello

Does anyone have any views on how many laps / races /test that the Dunlop Comer Cadet Tyres last before they are dead?

We are having problems and cannot get a balance the tyres are pretty old but measure spot on with a durometer.

How many laps are they good for?

Thanks lots


Spice
Spice52 is offline  
Quote
Old 3 Mar 2011, 20:03 (Ref:2839824)   #2
tator2001uk
Racer
 
Join Date: Nov 2001
United Kingdom
Cheshire
Posts: 415
tator2001uk should be qualifying in the top 10 on the grid

HI if you mean slicks, take the top layer off them with a heat gun, just make sure if racing that you have not got warm tyres when on the grid.

Some of my drivers have used slicks that have gone past the wear indicators and been as fast as drivers on new. Depends on the whole kart set up, if only practising keep the rubber fresh by taking older rubber off with a heat gun. Use them till they meet the indicators unless you are wearing one side not the other.

If you are only practising etc, try going to a meeting or looking on the adverts on the karting.co.uk website for 1 meeting old slicks you pay £10-£20 and can use them for a fair few laps
tator2001uk is offline  
Quote
Old 15 Jul 2011, 20:22 (Ref:2927207)   #3
knighty
Veteran
 
knighty's Avatar
 
Join Date: Nov 2005
England
Essex
Posts: 1,406
knighty should be qualifying in the top 5 on the gridknighty should be qualifying in the top 5 on the grid
very interesting......I am just completing the rebuild of a cadet kart for my 5.5 year old son, the kart has aparrently been in a shed for 2 years.......tyres are SL3's......will the tyres be rotten, or could I apply the paint gun trick......I have seen the paint gun trick used in the BTCC and it certainly makes the tyres heat up a great deal quicker......I must say the tyres dont look to bad, but I dont have a durometer......if I did have a durometer what hardness should they be???
knighty is offline  
Quote
Old 16 Jul 2011, 07:34 (Ref:2927333)   #4
karting
Racer
 
Join Date: Apr 2011
Posts: 184
karting should be qualifying in the top 10 on the grid
personally i wouldn't use 2-3year old slicks, not even for a practise day, just because of the fact they could of cracked.

Go to a club meeting which races your kids class and off pennies for there tyres which there gonna throw away
karting is offline  
Quote
Old 29 Aug 2011, 20:47 (Ref:2947938)   #5
Rennen
Veteran
 
Join Date: Oct 2001
United Kingdom
Hertfordshire
Posts: 2,056
Rennen should be qualifying in the top 3 on the gridRennen should be qualifying in the top 3 on the gridRennen should be qualifying in the top 3 on the gridRennen should be qualifying in the top 3 on the grid
We raced in Cadet 60cc Comer when the tyres were introduced in 1990, and raced using them for 2 seasons.

Basically the slicks gave 'too much' grip and sapped too much power from the motor. So the harder, more worn out they are the better!

I say this as someone who ran Cadet Karts for several drivers over 4 years before and after the Dunlop tyre was introduced. Whilst we lacked the engine 'preperation' of the fastest competitors that won the Championship titles, we were always a front runner in the Super One series winning several very low single digit number plates.
Rennen is offline  
Quote
Old 14 Sep 2011, 19:24 (Ref:2955594)   #6
knighty
Veteran
 
knighty's Avatar
 
Join Date: Nov 2005
England
Essex
Posts: 1,406
knighty should be qualifying in the top 5 on the gridknighty should be qualifying in the top 5 on the grid
Rennen - do you remember what sort of toe settings and tyre pressures you were using for the dunlop comer cadet tyres???......upon my sons first run at tilbury (hes only 5 years old) I tend to agree with what you say, the tyres were super sticky, I was running 14psi both front and rear and the front toe was seat at 1mm toe-in per rim.......he was just tootling around at 20mph (I restricted the speed) and I was quite surprised to see the tyres were literally melting, admittedley it was a very sunny and warm day (circa 25-28DegC).....anyway some pointers on front toe and tyre pressures would be appreciated????
knighty is offline  
Quote
Old 15 Sep 2011, 18:18 (Ref:2956045)   #7
tator2001uk
Racer
 
Join Date: Nov 2001
United Kingdom
Cheshire
Posts: 415
tator2001uk should be qualifying in the top 10 on the grid
14 to low
if no lead on kart to make msa weight try 18-22psi all round
tator2001uk is offline  
Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is Off
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
New Comer Richy888 National & Club Racing 25 16 Oct 2008 20:17
Can we race a Comer S60 benno1976a Kart Racing 1 16 May 2008 08:20
Cadet question Dunzer Kart Racing 1 20 Feb 2007 16:54
cadet technical help Paulc Kart Racing 4 2 Dec 2006 18:09


All times are GMT. The time now is 03:30.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Original Website Copyright © 1998-2003 Craig Antil. All Rights Reserved.
Ten-Tenths Motorsport Forums Copyright © 2004-2021 Royalridge Computing. All Rights Reserved.
Ten-Tenths Motorsport Forums Copyright © 2021-2022 Grant MacDonald. All Rights Reserved.