|
| Site Partners: | SpotterGuides | Veloce Books |
| Related Sites: | Your Link Here |
|
|
|||||||||
|
||||||||||
|
|
|||||||||
|
||||||||||
|
|
23 Oct 2018, 10:59 (Ref:3858589)
|
#1 | ||
|
Rookie
Join Date: Sep 2018
Posts: 5
 |
lola b99 engine fitting/ stress questions
Dear all.
I want to install a solution F 3.5 engine in a lola b99. However the version i bought is the one used STCC. I have several stress and fitting concerns. Im trying to do the installation based on already made one on a lola t96 with nissan aer p25 (same engine block as mine and same grbox). There is a problem with the heads. and might need to be changed as the one i have have no bore in the cylinder head cover to pass the bulkead studs and spread load along the head, currently talking with Solution F about how to solve this, same problem in the back of the engine. Apart of this in the lola t96 installation the bulkead top support plates that holds the upper studs is also bolted on the side of the tub. I wonder if that is really required, as the original car has no thread inserts there, and if the original configuration was able to handle the zytek engine why not the solution F ? any insight ? Also due to the need of a sandwich plate between engine and grbox in the t96, the grbox output shaft has be enlarged 1 cm. However is not easy to get this shaft manufacture. as workaround to this would be possible to place a 1cm alloy spacer between crankshaft and flywheel ? Last edited by Adam43; 23 Oct 2018 at 18:14. Reason: Removed link |
||
|
|
|
23 Oct 2018, 18:14 (Ref:3858671)
|
#2 | ||
|
14th
1% Club
Join Date: Jul 2001
Posts: 44,194
 |
Welcome to tentenths. Could you post your photos here please. Thanks
|
||
|
|
__________________
Brum brum
|
|
22 Jan 2019, 18:20 (Ref:3877757)
|
#3 | ||
|
Rookie
Join Date: Sep 2018
Posts: 5
|
Been busy...
Some progress has been done, both cars has been 3d scanned (engine grbox and tube) a initial design of the engine-grbox plate has been done. Now we will try to verify that all fixing points of the plate matches accurately with grbox and engine. in meantime grbox is being rebuilt, new longer input shaft is being done. Flywheel is being also manufactured based on original Solution F flywheel (however instead of carbon, will be done for metallic stepped flywheel) the engine with the open airbox is the original used in world series and mine has been used in european tourism champ, as you can see we will have to put alloy cam cover so we can have fix to the tub some pics here and more in the pdf report. |
||
|
|
|
Linear Mode
