Home  
Site Partners: SpotterGuides Veloce Books  
Related Sites: Your Link Here  

Go Back   TenTenths Motorsport Forum > Racing Talk > Racing Technology

Reply
 
Thread Tools Display Modes
Old 14 Dec 2016, 17:41 (Ref:3696179)   #1
Goran Malmberg
Registered User
Racer
 
Join Date: Mar 2004
Sweden
Stockholm Sweden
Posts: 319
Goran Malmberg should be qualifying in the top 10 on the grid
Ethanol in the oil.

https://youtu.be/AELXSsFHvWY
I made a short film about whether the oil in an engine is diluted by running on E85. It flourishes strong rumors that this is the case, the motors therefore tear up themself after a few mil. Sounds awful, I do not want to ruin my expensive engine that way. Time to therefore check the state of the oil after 3000 kilometers. It shows that new oil need 10 sec to flow through an orifice, my used oil needed the same 10 sec. I then diluted the oil with 25% ethanol and then the oil passed at 3 sec. As usual, the alarm is heavy over estimated.
Goran Malmberg is offline  
Quote
Old 14 Dec 2016, 20:17 (Ref:3696215)   #2
greenamex2
Veteran
 
Join Date: Aug 2002
England
Hertfordshire
Posts: 1,686
greenamex2 should be qualifying in the top 10 on the grid
Quote:
Originally Posted by Goran Malmberg View Post
https://youtu.be/AELXSsFHvWY
I made a short film about whether the oil in an engine is diluted by running on E85. It flourishes strong rumors that this is the case, the motors therefore tear up themself after a few mil. Sounds awful, I do not want to ruin my expensive engine that way. Time to therefore check the state of the oil after 3000 kilometers. It shows that new oil need 10 sec to flow through an orifice, my used oil needed the same 10 sec. I then diluted the oil with 25% ethanol and then the oil passed at 3 sec. As usual, the alarm is heavy over estimated.
Thanks Goran, educational even if I don't understand the language.
greenamex2 is offline  
Quote
Old 15 Dec 2016, 07:29 (Ref:3696335)   #3
Goran Malmberg
Registered User
Racer
 
Join Date: Mar 2004
Sweden
Stockholm Sweden
Posts: 319
Goran Malmberg should be qualifying in the top 10 on the grid
Quote:
Originally Posted by greenamex2 View Post
Thanks Goran, educational even if I don't understand the language.
The film does show the time it takes for the oil to pass the orifice, sort of showing the fact. Now the issue is more complicated than this simple test. If there is interest I may publish some more later on.
Goran Malmberg is offline  
Quote
Old 20 Apr 2017, 04:48 (Ref:3727912)   #4
Notso Swift
Veteran
 
Notso Swift's Avatar
 
Join Date: Apr 2006
United Nations
37deg 46'52.36" S 144deg 59' 01.83"E
Posts: 1,943
Notso Swift should be qualifying in the top 10 on the grid
The issue with ethanol in the oil is that (being hygroscopic) it will hold water that with race car engines (or anything else idle for extended time) will lead to pitting in the bearings from corrosion, found this one the hard way
My engine builder advised the Simple fix is to change the oil after an event not before
Road cars are not an issue if they are run to temp and not sitting
Notso Swift is offline  
__________________
Contrary to popular opinion, I do have mechanical sympathy, I always feel sorry for the cars I drive.
Quote
Old 21 Apr 2017, 09:51 (Ref:3728137)   #5
AndrewBurreh
Rookie
 
Join Date: Apr 2017
Posts: 1
AndrewBurreh should be qualifying in the top 10 on the grid
Hey, would it be possible for you to add subtitles to the video? Doesn't matter if in English or Norwegian - youtube can automatically translate subtitles to other languages.
AndrewBurreh is offline  
Quote
Old 21 Apr 2017, 10:12 (Ref:3728144)   #6
JohnD
Veteran
 
JohnD's Avatar
 
Join Date: Sep 2003
Location:
North West UK
Posts: 1,074
JohnD should be qualifying in the top 5 on the gridJohnD should be qualifying in the top 5 on the grid
Goran,
Quote your OP, "new oil need 10 sec to flow through an orifice, my used oil needed the same 10 sec."

In other words there was no effect. Purposely diluting the oil with ethanol (what a terrible use for snapps!) and finding that it is less viscous is what is predicted, and shows your engine oil isn't diluted.

You're worrying about something you need not worry about!
John
JohnD is offline  
Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Radiator type oil coolers vs Laminar oil/water heat exchanger type.. Zico Racing Technology 3 2 Sep 2008 20:46
Treating Oil on a wet Track? (merged with 'Oil on the track') Andrew Palmer Marshals Forum 25 9 May 2005 18:43
running Chevrolet and Ford 6 litre V8s on bio-ethanol? DanJR1 Racing Technology 1 23 Oct 2004 18:50
Ethanol macdaddy IRL Indycar Series 22 23 Nov 2003 20:25


All times are GMT. The time now is 01:31.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Original Website Copyright © 1998-2003 Craig Antil. All Rights Reserved.
Ten-Tenths Motorsport Forums Copyright © 2004-2021 Royalridge Computing. All Rights Reserved.
Ten-Tenths Motorsport Forums Copyright © 2021-2022 Grant MacDonald. All Rights Reserved.