![]() |
![]() |
|||||||||
|
||||||||||
![]() |
![]() |
|||||||||
|
||||||||||
![]() |
![]() |
![]() |
#1 | |
Rookie
Join Date: Sep 2004
Posts: 25
![]() |
PI System 2 and MBE ECU - Settings
I'm having problems getting my PI System 2 dash to read the tacho signal from my 967 MBE ecu!
Have set the dash to accept 12v Pull-Up (Config C). Have set the pulses per 2 revolutions of crank to 4. For some reason the rpm ground connector on the back of the PI Dash has never been used to ground to a supply (car used to be a Zetec FF). Even when I earth this pin, there is no change. Anybody any ideas ?? Cheers. |
|
![]() |
![]() |
![]() |
#2 | ||
Racer
Join Date: Aug 2003
Posts: 167
![]() |
What exactly is the problem?
Is the RPM intermittant, incorrect or not there at all? |
||
![]() |
__________________
"Ah," said Dirk "it is a rare mind indeed that can render the hitherto non-existent blindingly obvious." ![]() |
![]() |
#3 | |
Rookie
Join Date: Sep 2004
Posts: 25
![]() |
I'm getting no reading whatsoever !
|
|
![]() |
![]() |
![]() |
#4 | ||
Racer
Join Date: Aug 2003
Posts: 167
![]() |
Check your PMs...
|
||
![]() |
__________________
"Ah," said Dirk "it is a rare mind indeed that can render the hitherto non-existent blindingly obvious." ![]() |
![]() |
#5 | |
Rookie
Join Date: Sep 2004
Posts: 25
![]() |
Have set PPM to 4. Not joy. Tried 10, 20, 30 etc. still not joy
|
|
![]() |
![]() |
![]() |
#6 | ||||
Racer
Join Date: Aug 2003
Posts: 167
![]() |
Quote:
|
||||
![]() |
__________________
"Ah," said Dirk "it is a rare mind indeed that can render the hitherto non-existent blindingly obvious." ![]() |
![]() |
#7 | |||
Racer
Join Date: Aug 2003
Posts: 167
![]() |
Quote:
![]() |
|||
![]() |
__________________
"Ah," said Dirk "it is a rare mind indeed that can render the hitherto non-existent blindingly obvious." ![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Tracking Settings | Pug620 | Racing Technology | 6 | 24 May 2005 08:38 |
Camara Settings | rdjones | Motorsport Art & Photography | 3 | 23 Jan 2005 12:30 |